Region-Name - HP 3100 v2 Series Command Reference Manual

Default level
2: System level
Parameters
instance-id: Specifies an MSTI ID. The minimum value is 0, representing the CIST.
•
In MSTP mode, the instance-id argument ranges from 0 to 16.
•
In PVST mode, the instance-id argument ranges from 0 to 16.
vlan vlan-list: Specifies a VLAN list in the format of vlan-list = { vlan-id [ to vlan-id ] }&<1-10>, where
the vlan-id argument represents the VLAN ID, in the range of 1 to 4094, and &<1-10> indicates that
you can specify up to 10 VLAN IDs or VLAN ID ranges.
Description
Use instance to map a list of VLANs to the specified MSTI.
Use undo instance to remap the specified VLAN or all VLANs to the CIST (MSTI 0).
By default, all VLANs are mapped to the CIST.
If you specify no VLAN in the undo instance command, all VLANs mapped to the specified MSTI will
be remapped to the CIST.
You cannot map the same VLAN to different MSTIs. If you map a VLAN that has been mapped to an
MSTI to a new MSTI, the old mapping will be automatically removed.
In PVST mode, you can map multiple VLANs to the CIST, and only one VLAN to each remaining
MSTI.
After configuring this command, run the active region-configuration command to activate the
VLAN-to-instance mapping.
Related commands: display stp region-configuration, check region-configuration, and active
region-configuration.
Examples
# Map VLAN 2 to MSTI 1.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] instance 1 vlan 2

region-name

Syntax
region-name name
undo region-name
View
MST region view
Default level
2: System level
Parameters
name: Specifies the MST region name, a string of 1 to 32 characters.
Description
Use region-name to configure the MST region name.
Use undo region-name to restore the default MST region name.
104