Stp Port Shutdown Permanent; Stp Port-Log - HP 3100 v2 Series Command Reference Manual

[Sysname-Ethernet1/0/3] stp instance 2 port priority 16
# In PVST mode, set the priority of port Ethernet 1/0/3 to 16 in VLAN 2.
<Sysname> system-view
[Sysname] stp mode pvst
[Sysname] interface ethernet 1/0/3
[Sysname-Ethernet1/0/3] stp vlan 2 port priority 16

stp port shutdown permanent

Syntax
stp port shutdown permanent
undo stp port shutdown permanent
View
System view
Default level
2: System level
Description
Use stp port shutdown permanent to disable the device to reactivate edge ports shut down by
BPDU guard.
Use undo stp port shutdown permanent to restore the default.
By default, the device reactivates the shutdown edge ports after a port status detection interval.
This command disables the device to reactivate edge ports that are shut down after the stp port
shutdown permanent command is configured. These edge ports will remain down after you
execute the undo stp port shutdown permanent command. To reactivate these edge ports, you
must use the undo shutdown command.
You can use the shutdown-interval time command to set the port status detection interval after
which the device reactivates the shutdown ports. For information about the shutdown-interval time
command, see Fundamentals Command Reference.
Examples
# Disable the device to reactivate edge ports shut down by BPDU guard.
<Sysname> system-view
[Sysname] stp port shutdown permanent

stp port-log

Syntax
stp port-log { instance { instance-id | all } | vlan vlan-list }
undo stp port-log { instance { instance-id | all } | vlan vlan-list }
View
System view
Default level
2: System level
120