Port; Port Access Vlan - HP 3100 v2 Series Command Reference Manual

Field
Untagged

port

Syntax
port interface-list
undo port interface-list
View
VLAN view
Default level
2: System level
Parameters
interface-list: Specifies an interface list, in the format of interface-list = { interface-type
interface-number [ to interface-type interface-number ] }&<1-10>, where interface-type
interface-number represents the interface type and interface number and &<1-10> indicates that you
can specify up to 10 interface-type interface-number [ to interface-type interface-number ]
parameters.
Description
Use port to assign the specified access ports to the VLAN.
Use undo port to remove the specified access ports from the VLAN.
By default, all ports are in VLAN 1.
This command is applicable only on access ports.
By default, all ports are access ports. However, you can manually configure the port type. For more
information, see
You cannot assign Layer 2 aggregate interfaces to a VLAN.
Related commands: display vlan.
Examples
# Assign Ethernet 1/0/1 through Ethernet 1/0/3 to VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] port ethernet 1/0/1 to ethernet 1/0/3

port access vlan

Syntax
port access vlan vlan-id
undo port access vlan
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Description
VLANs for which the port sends packets after removing VLAN tags
"port link-type."
146