Snmp-Agent Trap Enable Fc-Fabric - HP 6127XLG Blade Series Command Reference Manual

Usage guidelines
Only FCF switches and VSANs operating in FCF mode support this command.
The RSCN aggregation timer takes effect only when RSCN aggregation is enabled.
HP recommends that you enable RSCN aggregation and set the same RSCN aggregation timer value on
all switches in a VSAN.
Examples
# Set the RSCN aggregation timer to 1500 milliseconds for VSAN 1.
<Sysname> system-view
[Sysname] vsan 1
[Sysname-vsan1] rscn aggregation timer 1500
Related commands
rscn aggregation enable

snmp-agent trap enable fc-fabric

Use snmp-agent trap enable fc-fabric to enable SNMP notifications for the fabric module.
Use undo snmp-agent trap enable fc-fabric to disable SNMP notifications for the fabric module.
Syntax
snmp-agent trap enable fc-fabric [ domain-id-change | fabric-change ] *
undo snmp-agent trap enable fc-fabric [ domain-id-change | fabric-change ] *
Default
All SNMP notifications for the fabric module are disabled.
Views
System view
Predefined user roles
network-admin
Parameters
domain-id-change: Specifies domain ID changes.
fabric-change: Specifies fabric changes.
Usage guidelines
Only FCF and FCF-NPV switches support this command.
If you do not specify any keywords, this command enables all SNMP notifications for the fabric module.
After you enable SNMP notifications for domain ID changes, the switch generates a notification when its
domain ID changes in a VSAN. The notification includes the VSAN ID, the switch WWN, and the new
domain ID.
After you enable SNMP notifications for fabric changes, the switch generates a notification when it sends
or receives a BF or RCF frame for fabric reconfiguration. The notification includes the VSAN ID for fabric
reconfiguration.
Generated notifications are sent to the SNMP module. For more information about SNMP notifications,
see Network Management and Monitoring Configuration Guide.
46