Mts - Downloading Ki's From The Auc To Kvl (Locally); Mts - Downloading Ki's From The Auc To Kvl (Remotely Using Gsm) - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS - Downloading Ki's from the AuC to KVL (Locally)

MTS - Downloading Ki's from the AuC to KVL (Locally)
Procedure 8-17 MTS - How to Download Locally Ki's from the AuC to KVL
On the AuC Client, select SYSTEM > PREFERENCES > PORTSETTINGS and then verify
1
the port configurations are set to local and 19200.
Using a null modem cable from the AuC COM port 1 to the KVL device select Au/Prc from the
2
KVL main menu, then DIRECT, then RS232.
The AuC event log will display successful connection from the KVL before allowing the
3
upload/download process to start.
Result: The KVL will collect the Ki's from the AuC. Allow approximately one minute for the
process to complete.
Upon completion the AuC event log will display a success message and the KVL will also
4
acknowledge successful download by emitting an alternating hi/low tone and displaying message
Download Completed Successfully.
Press OK on KVL.
5
Continue to
6

MTS - Downloading Ki's from the AuC to KVL (Remotely Using GSM)

Procedure 8-18 MTS - How to Download Ki's from the AuC to KVL (Remotely using GSM)
Contact the on site switch engineer and verify that the AuC is set for remote access.
1
Connect GSM to KVL through modified adapter (Motorola phones only).
2
Contact the switch site and verify the telephone number needed to access the AuC.
3
On the KVL select Au/Prc from the main menu, then MODEM, then RS232.
4
At this point there will be a telephone number displayed. Edit this number as appropriate for the
5
Cluster Site you require, once the number is correct select ENTER and then DIAL.
If there is someone at the switch site then they can verify that the KVL connects to the AuC
6
correctly by monitoring the event log.
The KVL will collect the Ki's from the AuC. The time taken will depend on the number of sites
7
assigned to the Zone and can take up to 3 minutes for a full zone.
Upon completion the AuC event log will display a success message and the KVL will also
8
acknowledge successful download by emitting an alternating hi/low tone. The call on the cell
phone will be dropped before this success tone is emitted.
Continue to
9
8-36
"MTS - Checking the Inventory in KVL" on page
This is carried out by going to the AuC Client select SYSTEM > SETTINGS and
then verify the port configurations are set to MODEM and 9600.
"MTS - Checking the Inventory in KVL" on page
.
8-37.
8-37.
Chapter 8: Site Controller
6802800U74-N September 2009