Subaru IMPREZA 2002 Service Manual page 320

GENERAL DESCRIPTION
CLUTCH SYSTEM
Circuit Tester
Dial Gauge
C: CAUTION
Wear working clothing, including a cap, protec-
tive goggles, and protective shoes during opera-
tion.
Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
Keep the disassembled parts in order and pro-
tect them from dust or dirt.
Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly, and replacement.
Be careful not to burn your hands, because each
part on the vehicle is hot after running.
Use SUBARU genuine fluid, grease etc. or the
equivalent. Do not mix fluid, grease etc. with that of
another grade or from other manufacturers.
D: PREPARATION TOOL
Used for measuring resistance, voltage and ampere.
Used for measuring clutch disk run-out.
1. SPECIAL TOOLS
I
B2M3853
B2M4112
TOOL NUMBER
4984971 00
4997471 00
2. GENERAL PURPOSE TOOLS
Be sure to tighten fasteners including bolts and
nuts to the specified torque.
Place shop jacks or safety stands at the specified
points.
Apply grease onto sliding or revolution surfaces
before installation.
Before installing O-rings or snap rings, apply suf-
ficient amount of fluid to avoid damage and defor-
mation.
Before securing a part on a vice, place cushion-
ing material such as wood blocks, aluminum plate,
or shop cloth between the part and the vice.
Keep fluid away from the vehicle body. If any flu-
id contacts the vehicle body, immediately flush the
area with water.
DESCRlPTtON
CRANKSHAFT
STOPPER
CLUTCH DISC
GUIDE
REMARKS
Used for stopping rotation
of flywheel when Ioos.
eninghightening bolt, etc.
Used when installing clutch disc to flywheel.
TOOL NAME
REMARKS
I
CL-10