SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
AUTOMATIC TRANSMISSION
I
I
9) Raise the vehicle and drain the ATF
14) Remove the select cable nut.
(A) Oil pan
(B) Drain plug
(C) Defferential oil drain plug
10) Remove the heat shield cover. (If equipped)
11) Remove the propeller shaft. <Ref. to DS-14,
REMOVAL, Propeller Shaft.>
12) Remove the rear crossmember.
-_
.(1) Support the transmission using a transmis-
sion jack and raise slightly.
(2) Remove the bolts and nuts as shown in the
figure.
13) Remove the rear vehicle speed sensor
G3M0308
15) Move the gear select cable so that extension
bolts can be removed.
16) Remove the bolts.
17) Remove the extension case.
NOTE:
Use a container to catch oil flowing from extension.
18) Disconnect the transfer duty solenoid connec-
tor.
19) Remove the transfer duty solenoid and transfer
valve body.
B3M1045F
(A) Transfer valve body
(B) Transfer duty solenoid connector
(C) Transfer duty solenoid
AT-40