Subaru IMPREZA 2002 Service Manual page 37

I
CONTROL SYSTEMS
MT GEAR SHIFT LEVER
D: ASSEMBLY
1) Clean all parts before assembly.
2) Mount the bushing B and cushion rubber on the
stay.
B3M0830C
(A) Bushing
(6) Cushion rubber
3) Mount each part; boot, O-ring, bush, spacer,
bush A, bush B and straight pin on the gear shift le-
ver.
CAUTION:
Always use new O-rings.
Apply grease [DNIGTIGHT LYW No. 2 or
equivalent] to the inner and side surfaces of the
bushing when installing the spacer.
..-
-
L
B3M0623C
(A) Boot
(6) O-ring B
(C) Bushing
(D) Spacer
(E) BushingA
(F) Bushing E 3
(G) Spring pin
(H) O-ring A
4) Insert the gear shift lever into the boot hole.
5) Install the snap ring and stay to the bushing B.
B3M0619C
(A) Snap ring
(6) Bushing B
6) Tighten with locking wire to the extent that the
boot will not come off.
CAUTION:
Always use new locking wire.
(A) Locking wire
(6) Stay
7) Insert the rod into the boot hole.
8) Connect the rod to gear shift lever.
Tightening torque:
11.8 N.m (1.2 kgf-m, 8.7 fi-lb)
n
(A)
Rod
(6) Shift lever
(C) Stay
cs-35