Subaru IMPREZA 2002 Service Manual page 27

I
SELECT LEVER
CONTROL SYSTEMS
the select lever upper from plate.
10)
Remove the select lever lower then take away
1 1 )
Remove the spring and remove the detent arm.
dA'
B3M1848A
(A)
Select lever lower
(B) Select lever upper
(C) Plate
(A)
Detent arm
(B) Spring
12)
Remove the cushion.
D: ASSEMBLY
1) Clean all parts before assembly.
2) Apply grease [NIGTIGHT LYW No.
2 or equiva-
lent] to each parts. <Ref. to CS-3, AT Select Le-
ver.>
3) Assembly is in the reverse order of disassembly.
4) After completion of fitting, transfer the select le-
ver to range "P" -
"l", then check whether the in-
dicator and select lever agree, whether the pointer
and position mark agree and what the operating
force is.
E: INSPECTION
1)
Inspect the removed parts by comparing with
new ones for deformation, damage and wear. Cor-
rect or replace if defective.
2) Confirm the following parts for operating condi-
tion before assembly. Moving condition of the se-
lector lever upper, it should move smoothly.
CS-25