Subaru IMPREZA 2002 Service Manual page 284

MAIN SHAFT ASSEMBLY FOR SINGLE-RANGE
I
MANUAL TRANSMISSION AND DIFFERENTIAL
5) Drive the ball bearing onto the rear section of
transmission main shaft using ST1, ST2 and a
press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1
US ton, 1
.O
Imp ton).
ST1 89971 41 10 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
6) Using ST1 and ST2, install the 5th gear thrus
iasher and 5th needle bearing race onto the rear
section of transmission main shaft.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1 .O Imp ton).
NOTE:
Face the thrust washer in the correct direction.
ST1 89971 41 10 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
.
B3M0091 D
(A) Face this surface to 5th gear side.
7) Install the bearing onto synchro cone.
8) Install the baulk ring and synchro cone onto 5th-
Rev sleeve and hub assembly using ST and a
press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
NOTE:
Use new ball bearing.
After press fitting, make sure synchro cone ro-
tates freely.
ST 499757002 INSTALLER
(A) Baulk ring
(B) Synchro cone
(C) Ball bearing
9) Install the synchro cone stopper and snap ring to
5th-Rev sleeve and hub assembly.
u
B3M04358
(A) Synchro cone stopper
(B) Snap ring
MT-60