I
TRANSMISSION MOUNTING SYSTEM
MANUAL TRANSMISSION AND DIFFERENTIAL
2. CROSSMEMBER AND CUSHION RUB-
C: INSPECTION
BER
1) Install for rear cushion rubber.
Tigh fening torque:
35 N-m (3.6 kgf-m, 26 ff-lb)
2 ) Install the crossmember.
Tigh fening torque:
T I : 70 N.m (7.1 kgf-m, 51 ff-lb)
T2: 140 N-m (14.3 kgf-m, 103 ff-lb)
3) Remove the transmission jack.
4) Install the heat shield cover. (If equipped)
5) Install the front and center exhaust pipes. (Non-
turbo model)
<Ref. to EX(-S0HC)-6, INSTALLATION, Front Ex-
haust Pipe.>
6) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(D0HC TURBO)-9, INSTALLATION,
Center Exhaust Pipe.>
7) Install the rear exhaust pipe and muffler.
Repair or replace parts if the results of the inspec-
tion below are not satisfactory.
1. PITCHING STOPPER
Make sure that the pitching stopper is not bent or
damaged. Make sure that the rubber is not stiff,
cracked, or otherwise damaged.
BER
Make sure that the crossmember is not bent or
damaged. Make sure that the cushion rubber is not
stiff, cracked, or otherwise damaged.
2.
CROSSMEMBER AND CUSHION RUB-
MT-35