Clutch Pedal - Subaru IMPREZA 2002 Service Manual

CLUTCH SYSTEM
I
CLUTCH PEDAL
I
1O.Clutch Pedal
A: REMOVAL
1) Remove the steering column. <Ref. to PS-23,
REMOVAL, Tilt Steering Column.>
2) Disconnect the connectors from stop light and
clutch switches.
3) Remove the snap pins which secure lever to
push rod and operating rod.
4) Remove the clevis pins which secure lever to
push rod and operating rod.
(A) Operating rod
(B) Push rod
(C) Snap pin
(D) Clevis pin
5 ) Remove the air cleaner case and intake duct.
(Non-turbo model) <Ref. to IN(S0HC)-6, REMOV-
AL, Air Cleaner Case.> and <Ref. to IN(S0HC)-7,
REMOVAL, Air Intake Duct.>
6) Remove intercooler. (Turbo model) <Ref. to
IN(D0HC TURBO)-1 0, REMOVAL, Intercooler.>
7) Remove the nut which secures clutch master
cylinder.
8) Remove the bolts and nuts which secure brake
and clutch pedals, and remove pedal assembly.
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
If the cable clamp is damaged, replace it with
a new one.
Never fail to cover outer cable end with boot.
Be careful not to kink the accelerator cable.
Always use a new clevis pins.
2) Adjust the clutch pedal after installation.<Ref. to
CL-27, ADJUSTMENT, Clutch Pedal.>
C: DISASSEMBLY
1) Remove the clutch switches.
2) Remove the clips, assist spring, rod and bush-
ing.
3) Remove the spring pin and lever.
02M4115A
(A) Clip
(B) Assist spring
(C) Assist rod
(D) Bushing
(E) Clevis pin
(A) Pin
(B) Lever
C L-26