Flywheel - Subaru IMPREZA 2002 Service Manual

FLYWHEEL
I
CLUTCH SYSTEM
3. Flywheel
A: REMOVAL
1) Remove the transmission assembly. <Ref. to
MT-27, REMOVAL, Manual Transmission Assem-
bly.>
2) Remove the clutch cover and clutch disc. <Ref.
to CL-11, REMOVAL, Clutch Disc and Cover.>
CAUTION:
Take care not to allow oil on the clutch disc
facing.
Do not disassemble either the clutch cover or
clutch disc.
3) Using ST, remove the flywheel.
ST
r .
4984971 00 CRANKSHAFT STOPPER
- .
'
B2M0332B
(A) Flywheel
B: INSTALLATION
1) Install the flywheel and ST.
ST 4984971 00 CRANKSHAFT STOPPER
2) Tighten the flywheel attaching bolts to the spec-
ified torque.
NOTE:
Tighten the flywheel installing bolts gradually. Each
bolt should be tightened to the specified torque in
a crisscross method.
Tightening torque:
72 N-m (7.3 kgf-m, 52.8 ft-lb)
3) Install the clutch disc and cover. <Ref. to CL-11,
INSTALLATION, INSTALLATION, Clutch Disc and
Cover. >
4) Install the transmission assembly. <Ref. to MT-
30, INSTALLATION, Manual Transmission Assem-
bly.>
C: INSPECTION
CAUTION:
Since this bearing is grease sealed and is of a
non-lubrication type, do not wash with gaso-
line or any solvent.
1) Damage of facing and ring gear:
If defective, replace the flywheel.
(A) Flywheel
(B) Ring gear
2) Smoothness of rotation:
Rotate the ball bearing applying pressure in thrust
direction.
3) If noise or excessive play is noted, replace the
flywheel.
CL-14