Subaru IMPREZA 2002 Service Manual page 321

1
CLUTCH DISC AND COVER
CLUTCH SYSTEM
2. Clutch Disc and Cover
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to MT-27, REMOVAL, Manual Trans-
mission Assembly.>
2) Install the ST on flywheel.
ST 499747100 CLUTCH DISC GUIDE
I I 1 1' 1
(A) Clutch cover
-.
-
.
3) Remove the clutch cover and clutch disc.
CAUTION:
Take care not to allow oil on the clutch disc
facing.
Do not disassemble either the clutch cover or
clutch disc.
B: INSTALLATION
1) Insert the ST into the clutch disc and install them
on the flywheel by inserting the ST end into the pi-
lot bearing.
ST 499747100 CLUTCH DISC GUIDE
G2M0253
2) Install the clutch cover on flywheel and tighten
bolts to the specified torque.
NOTE:
When installing the clutch cover on the flywheel,
position the clutch cover so that there is a gap of
120" or more between
"0'
marks on the flywheel
and clutch cover. ( " 0 marks indicate the directions
of residual unbalance.)
Note the front and rear of the clutch disc when in-
stalling.
Temporarily tighten the bolts by hand. Each bolt
should be tightened to the specified torque in a
crisscross method.
Tightening torque:
15.7 N-m (1.6 kgf-m, 11.6 ft-lb)
B2M 1
-
I0118
-
(A)
" 0
marks
3) Remove the ST.
ST 499747100 CLUTCH DISC GUIDE
4) Install the transmission assembly. <Ref. to MT-
30, INSTALLATION, Manual Transmission Assem-
bly.>
CL-11