Subaru IMPREZA 2002 Service Manual page 81

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Install the solenoids and ATF temperature sen-
sor.
Tightening torque:
T: 8 N-m (0.8 kgf-m, 5.8 ft-lb)
I
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
2) Connect the harness connectors.
Connect the connectors of same color, and secure
the connectors to valve body using clips.
c-
-
( G , CF,
B2M2263J
Lock-up duty solenoid (Blue)
Low clutch timing solenoid (Gray)
Line pressure duty solenoid (Red)
Shift solenoid 2 (Yellow)
Shift solenoid
1
(Green)
2-4 brake timing solenoid (Black)
2-4 brake duty solenoid (Red)
ATF temperature sensor
Transfer duty solenoid (Brown)
3) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
Fluid packing:
Tree Bond 12178
B3M 1040
4) Install the oil pan.
Tightening torque:
4.9 N.m (0.50 kgf-m, 3.6 ft-lb)
(A) Oil pan
(B) Drain plug
5 ) Fill ATF up to the middle of the "COLD" side on
level gauge by using the gauge hole. <Ref. to AT-9,
Automatic Transmission Fluid.>
6) Check the ATF level. <Ref. to AT-9, Automatic
Transmission Fluid.>
AT-4 1