Subaru IMPREZA 2002 Service Manual page 252

MANUAL TRANSMISSION ASSEMBLY
I
MANUAL TRANSMISSION AND DIFFERENTIAL
10) Separate the clutch release fork from the re-
lease bearing. (Turbo model)
(1) Remove the clutch operating cylinder from
the transmission.
(2) Remove the plug using 10 mm hexagon
wrench.
S2M1935
I
(3) Screw the 6 mm dia. bolt into the release
fork shaft, and remove it.
S2M1936A
(A) Shaft
(B) Bolt
(4) Raise the release fork and unfasten the re-
lease bearing tabs to free release fork.
CAUTION:
Step (4) is required to prevent interference with
engine when removing engine from transmis-
sion.
11) Set ST.
NOTE:
Also is available Part No. 927670000.
ST 41099AA020 ENGINE SUPPORT ASSY
12) Remove the bolt which holds right upper side of
transmission to the engine.
B2M2791
13) Remove the front and center exhaust pipes.
(Non-turbo model) with OBD <Ref. to EX(S0HC)-
5, REMOVAL, Front Exhaust Pipe.>
14) Remove the center exhaust pipe. (Turbo mod-
el). <Ref. to EX(D0HC TURBO)-8, REMOVAL,
Center Exhaust Pipe.>
15) Remove the rear exhaust pipe and muffler.
CAUTION:
When removing exhaust pipes, be careful each
exhaust pipe does not drop out.
16) Remove the heat shield cover. (If equipped)
17) Remove the hanger bracket from right side of
transmission.
I
I W '
I
I rJl \ \
0
B2M0032
18) Remove the propeller shaft. <Ref. to DS-14,
REMOVAL, Propeller Shaft.>
MT-28