Subaru IMPREZA 2002 Service Manual page 329

OPERATING CYLINDER
CLUTCH SYSTEM
2) After bleeding air from the operating cylinder, en-
sure that the clutch operates properly.
<Ref. to CL-24, Clutch Fluid Air Bleeding.>
C: INSPECTION
1) Check the operating cylinder for damage. If the
operating cylinder is damaged, replace it.
2) Check the operating cylinder for fluid leakage or
damage on boot. If any leakage or damage is
found, replace the operating cylinder.
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
Before installing the operating cylinder, apply
grease (SUNLIGHT 2: P/N 00360201 0) to the con-
tact point of release lever and operating cylinder.
Tightening torque:
T1: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
T2: 37 N-m (3.8 kgf-m, 27.5 ft-lb)
Non-turbo model
I
c .
.
Turbo model
NOTE:
Be sure to install the clutch hose with the mark
side facing upward.
Be careful not to twist the clutch hose during in-
stallation.
(A) Marking
(B) Clutch hose
(C) Operating cylinder
CL-19