Oil Seal - Subaru IMPREZA 2002 Service Manual

I
OIL SEAL
I
MANUAL TRANSMISSION AND DIFFERENTIAL
5. Oil Seal
A: INSPECTION
Inspect for oil leakage from the oil seal. Replace
the oil seal if the lips is deformed, hardened, dam-
aged, worn or defective if any.
B: REPLACEMENT
1) Clean the transmission exterior.
2) Drain the gear
oil
completely.
NOTE:
Tighten the drain plug after draining gear oil.
Tightening torque:
44 N.m (4.5 kgf-m, 32.5 ff-lb)
1
g
B3M0037
3) Remove the rear exhaust pipe and muffler,
4) Remove the heat shield cover. (If equipped)
5) Remove the propeller shaft. <Ref. to DS-14, RE-
MOVAL, Propeller Shaft.>
6) Using ST, remove the oil seal.
ST 398527700 PULLER ASSY
B3M2135A
(A) Oilseal
7 ) Using ST, install the oil seal.
ST 4$8057300 INSTALLER
B3M 1982
\
8) Install the propeller shaft. <Ref. to DS-15, IN-
STALLATION
,
P rope1 le r Shaft. >
9) Install the heat shield cover. (If equipped)
10) Install the rear exhaust pipe and muffler.
11) Pour the gear oil and check the oil level. <Ref.
to MT-26, Transmission Gear Oil.>
MT-36