Subaru IMPREZA 2002 Service Manual page 62

AUTOMATIC TRANSMISSION ASSEMBLY
I
AUTOMATIC TRANSMISSION
I
B: INSTALLATION
1) Install the rear cushion rubber to transmission
assembly.
Tightening torque:
2) Install the ST to torque converter clutch case.
ST 498277200 STOPPER SET
39 N.m (4.0 kgf-m, 29 ft-lb)
3) Install the transmission onto engine.
-_
.
(1) Gradually raise the transmission with trans-
mission jack.
(2) Engage them at splines.
4) Install the transmission rear crossmember.
Tightening torque:
T1: 35 N-m (3.6 kgf-m, 26 ft-lb)
T2: 70 Nom (7.1 kgf-m, 51.4 ft-lb)
6) Tighten the nuts and bolts which hold lower side
of transmission to engine.
Tightening torque:
50 N-m (5.1 kgf-m, 36.9 ft-lb)
7) Lower the vehicle.
8) Connect the engine and transmission.
(1) Remove the ST from torque converter clutch
case.
NOTE:
Be careful not to drop the ST into the torque con-
verter clutch case when removing the ST.
ST 498277200 STOPPER SET
(2) Install the starter.
<Ref. to SC-7, INSTALLATION, Starter.>
(3) Tighten the bolt which holds right upper side
of transmission to engine.
50 N.m (5.1 kgf-m, 36.9 ft-lb)
Tightening torque:
03M2044
5) Take off the transmission jack.
AT-22