Subaru IMPREZA 2002 Service Manual page 66

TRANSMISSION MOUNTING SYSTEM
I
AUTOMATIC TRANSMISSION
2. CROSSMEMBER AND CUSHION RUB-
C: INSPECTION
BER
1) Install the rear cushion rubber.
Tightening torque:
39 N.m (4.0 kgf-m, 29 ff-lb)
2 ) Install the crossmember.
Tightening torque:
T I : 35 N-m (3.6 kgf-m, 26 ft-lb)
T2: 70 N.m (7.1 kgf-m, 51.4 ff-lb)
c .
3) Remove the transmission jack.
4) Install the heat shield cover. (If equipped)
5 ) Install the front, center, rear exhaust pipes and
the muffler. (Non-turbo model)
<Ref. to EX(S0HC)-6, INSTALLATION, Front Ex-
haust Pipe.>, <Ref. to EX(S0HC)-9, INSTALLA-
TION, Rear Exhaust Pipe.> and <Ref. to
EX(S0HC)-1 1
,
INSTALLATION, Muffler.>
6) Install the center, rear exhaust pipes and muffler.
(Turbo model) <Ref. to EX(D0HC TURBO)-14, IN-
STALLATION, Muffler.>, <Ref. to EX(D0HC TUR-
BO)-1 3, INSTALLATION, Rear Exhaust Pipe.>,
<Ref. to EX(D0HC TURBO)-9, INSTALLATION,
Center Exhaust Pipe.>
Repair or replace parts if the results of the inspec-
tion below are not satisfactory.
1. PITCHING STOPPER
Make sure that the pitching stopper is not bent or
damaged. Make sure that the rubber is not stiff,
cracked, or otherwise damaged.
BER
Make sure that the crossmember is not bent or
damaged. Make sure that the cushion rubber is not
stiff, cracked, or otherwise damaged.
2. CROSSMEMBER AND CUSHION RUB-
AT-26