Transmission Mounting System - Subaru IMPREZA 2002 Service Manual

I
I
TRANSMISSION MOUNTING SYSTEM
MANUAL TRANSMISSION AND DIFFERENTIAL
4. Transmission Mounting Sys-
A: REMOVAL
tem
1. PITCHING STOPPER
1) Disconnect the battery ground terminal.
2) Remove the air intake duct and cleaner case.
3) Remove the air intake duct (Non-turbo model).
<Ref. to IN(S0HC)-7, REMOVAL, Air Intake Duct.>
4) Remove the air cleaner case (Non-turbo model).
<Ref. to IN(S0HC)-6, REMOVAL, Air Cleaner
Case.>
5) Remove the inter cooler (Turbo model). <Ref. to
IN(D0HC TURBO)-1 0, REMOVAL, Intercooler.>
6) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION RUB-
BER
1) Disconnect the battery ground terminal.
2) Jack-up the vehicle and support it with sturdy
racks.
3) Remove the front, center exhaust pipes. (Non-
turbo model)
<Ref. to EX(S0HC)-5, REMOVAL, Front Exhaust
Pipe.>
CAUTION:
When removing exhaust pipes, be careful each
exhaust pipe does not drop out.
4) Remove the center exhaust pipe. (Turbo model)
<Ref. to EX(D0HC TURBO)-8, REMOVAL, Center
Exhaust Pipe.>
5) Remove the rear exhaust pipe and muffler.
6) Remove the heat shield cover. (If equipped)
7) Set the transmission jack under the transmission
body.
CAUTION:
Always support transmission case with a trans-
mission jack.
8) Remove the rear crossmember.
'
G2M0831
7
C J
\
9) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N-m (5.1 kgf-m, 37 ff-lb)
T2: 58 N.m (5.9 kgf-m, 43 ff-lb)
2) Install the air intake duct and cleaner case. (Non-
turbo model)
<Ref. to IN(S0HC)-6, INSTALLATION, Air Cleaner
Case.> and <Ref. to IN(S0HC)-7, INSTALLATION,
Air Intake Duct.>
3) Install the intercooler. (Turbo model)
<Ref. to IN(D0HC TURBO)-1 1, INSTALLATION,
Intercooler.>
4) Connect the battery ground terminal.
MT-34