Subaru IMPREZA 2002 Service Manual page 305

SHIFTER FORK AND ROD
I
MANUAL TRANSMISSION AND DIFFERENTIAL
4) Align the holes in rod and fork, and drive straight
pin into these holes using ST.
CAUTION:
Replace straight pin with a new one.
NOTE:
Set other rods to neutral.
Make sure interlock plunger is on the 3-4 fork rod
side.
ST 398791700 STRAIGHT PIN REMOVER
5) Install the interlock plunger onto 3-4 fork rod.
CAUTION:
Apply a coat of grease to plunger to prevent it
from falling.
6) Install the 3-4 fork rod into 3-4 shifter fork via the
hole on the rear of transmission case.
7) Align the holes in rod and fork, and drive straight
pin into these holes.
CAUTION:
Replace straight pin with a new one.
Set the reverse fork rod to neutral.
Make sure the interlock plunger (installing be-
fore) is on the reverse fork rod side.
ST 398791700 STRAIGHT PIN REMOVER
8) Install the 5th shifter fork onto the rear of reverse
fork rod. Align the holes in the two parts and drive
straight pin into place.
CAUTION:
Replace straight pin with a new one.
ST 398791700 STRAIGHT PIN REMOVER
**
NOTE:
(
B3M0333J
9) Position the balls, checking ball springs and gas-
kets into 3-4 and 1-2 rod holes, and install plugs.
CAUTION:
Replace gasket with a new one.
33J
(A)
5th shifter fork
(B) Reverse fork rod
(C) Straight pin
10) Install the differential assembly. <Ref. to MT-
71
1
INSTALLATION, Front Differential Assembly.>
11) Install the main shaft assembly.
Single-range model:
<Ref. to MT-57, INSTALLATION, Main Shaft As-
sembly for Single-Range.>
12) Install the drive pinion shaft assembly. <Ref. to
MT-63, INSTALLATION, Drive Pinion Shaft As-
sembly.>
13) Install the transmission case. <Ref. to MT-55,
INSTALLATION, Transmission Case.>
14) Install the transfer case with extension case as-
sembly. <Ref. to MT-41, INSTALLATION, Transfer
Case and Extension Case Assembly.>
15) Install the back-up light switch and neutral po-
sition switch. <Ref. to MT-38, INSTALLATION,
Switches and Harness.>
16) Install the manual transmission assembly to ve-
hicle. <Ref. to MT-30, INSTALLATION, Manual
Transmission Assembly.>
(A)
5th shifter fork
(B) Reverse fork rod
(C) Straight pin
MT-81