Subaru IMPREZA 2002 Service Manual page 262

SWITCHES AND HARNESS
I
MANUAL TRANSMISSION AND DIFFERENTIAL
Neutral position
Other positions
B: INSTALLATION
TRAL POSITION SWITCH
1) Install the back-up light switch and neutral posi-
tion switch with harness.
Tightening torque:
1. BACK-UP LIGHT SWITCH AND NEU-
24.5 N.m (2.5 kgf-m, 18.1 fi-lb)
Less than
1R
More than 1 MR
1 and2 .
(A) Neutral switch
(B) Back-up light switch
2) Connect the connector of back-up light switch
and neutral position switch.
3) Install the air intake duct and cleaner case. (Non-
turbo model) <Ref. to IN(S0HC)-6, INSTALLA-
TION, Air Cleaner Case.> and <Ref. to IN(S0HC)-
7, INSTALLATION, Air Intake Duct.>
4) Install the intercooler. (Turbo model)
<Ref. to IN(D0HC TURBO)-I 1, INSTALLATION,
Intercooler.>
5 ) Connect the battery ground terminal.
--
-
Gear shift position
Neutral position
Other positions
C: INSPECTION
Inspect the back-up light switch. <Ref. to LI-6, IN-
SPECTION, Back-up Light System.>
2.
NEUTRAL POSITION SWITCH
1) Turn the ignition switch to OFF.
2) Disconnect the connector neutral position
switch.
3) Measure the resistance between neutral position
switch terminal.
Non-turbo model
I
Gear shift position
I
Terminal No.
I
Specified resistance
I
1. BACK-UP LIGHT SWITCH
Terminal No. Specified resistance
Less than 1R
More than 1 MR
1 and 3
Turbo model
TROlOl
4) Replace defective parts.
MT-38