Subaru IMPREZA 2002 Service Manual page 70

INHIBITOR SWITCH
I
AUTOMATIC TRANSMISSION
14) Remove the inhibitor switch from transmission.
(A) Inhibitor switch
15) Disconnect the inhibitor switch harness from in-
hibitor switch.
D: INSTALLATION
1) Connect the inhibitor switch harness to inhibitor
switch.
c .
2) Install the inhibitor switch to transmission case.
(A) Inhibitor switch
3) Move the range select lever to neutral position.
4) Using the ST, tighten bolts of inhibitor switch.
ST 499267300 STOPPER PIN
Tightening torque:
3.4 N-m (0.35 kgf-m, 2.5 ff-16)
(A) Inhibitor switch
(B) Range select lever
5) Install the select cable to range select lever.
6) Install the plate assembly to transmission.
Tightening torque:
T: 24.5 N.m (2.50 kgf-m, 18.1 ff-16)
(A) Select cable
(B) Plate ASSY
7 ) Install the snap pin to range select lever
(A) Snap ring
(B) Select cable
(C) Range select lever
8) Install the front exhaust pipe with center exhaust
pipe. (Non-turbo model)
<Ref. to EX(S0HC)-6, INSTALLATION, Front Ex-
haust Pipe.>
9) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(D0HC TURBO)-9, INSTALLATION,
Center Exhaust Pipe.>
10) Lower the vehicle.
11) Install the inhibitor switch connector from stay.
AT-30