Subaru IMPREZA 2002 Service Manual page 30

SELECT CABLE
I
CONTROL SYSTEMS
8) Turn the adjusting nut B until it lightly touches the
connector.
(A) Front side
(B) Select lever
(C) Connector
(D) Adjusting nut B
(E) Contact point
(F) Adjusting nut A
S).While preventing the adjusting nut B from mov-
ing with a wrench, tighten adjusting nut A.
Tightening torque:
7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
(A) Adjusting nut A
(B) Adjusting nut B
10) After completion of fitting, make sure that the
select lever operates smoothly all across the oper-
ating range.
11) Install in the reverse order of removal.
CS-28