Subaru IMPREZA 2002 Service Manual page 64

1
AUTOMATIC TRANSMISSION ASSEMBLY
I
AUTOMATIC TRANSMISSION
17) Install the propeller shaft.
<Ref. to DS-15, INSTALLATION, Propeller Shaft.>
18) Install the heat shield cover. (If equipped)
19) Install the front, center, rear exhaust pipes and
muffler. (Non-turbo model)
<Ref. to EX(S0HC)-6, INSTALLATION, Front Ex-
haust Pipe.>, <Ref. to EX(S0HC)-9, INSTALLA-
TION, Rear Exhaust Pipe.> and <Ref. to
EX(S0HC)-1 1 , INSTALLATION, Muffler.>
20) Install the center, rear exhaust pipes and muf-
fler. (Turbo model) <Ref. to EX(D0HC TURBO)-9,
INSTALLATION, Center Exhaust Pipe.>, <Ref. to
EX(D0HC TURBO)-13, INSTALLATION, Rear Ex-
haust Pipe.>, <Ref. to EX(D0HC TURBO)-14, IN-
STALLATION, Muff le r. >
21) Install the under cover.
22) Lower the vehicle.
23) Install the ATF level gauge.
32) Check the select lever operation.
<Ref. to AT-28, INSPECTION, Inhibitor Switch.>
33) Check the ATF level. <Ref. to AT-9, Automatic
Transmission Fluid.>
34) Check the vehicle on the road tester.
<Ref. to AT-1 2, Road Test.>
c .
.
24) Connect the following connectors:
(1) Transmission harness connectors
(2) Transmission ground terminal
25) Install the air cleaner case stay. (Non-turbo
model)
Tightening torque:
26) Install the air cleaner case. (Non-turbo model)
<Ref. to IN(S0HC)-6, INSTALLATION, Air Cleaner
Case.>
27) Install the air intake duct. (Non-turbo model)
<Ref. to IN(S0HC)-7, INSTALLATION, Air Intake
Duct.>
28) Install the intercooler. (Turbo model) <Ref. to
IN(D0HC TURBO)-1 1, INSTALLATION, Intercool-
er.>
29) Connect the battery ground terminal.
30) Fill ATF up to the middle of the "COLD" side on
level gauge by using the gauge hole.
Recommended fluid:
Fluid capacity:
16 N.m (1.6 kgf-m, 11.6 ft-16)
Dexron Ill type automatic transmission fluid
9.3-9.6
0
(9.8-10.1 USqt, 7.4-7.7lmp
qt)
31) Take off the vehicle from lift arms.
AT-24