Vehicle Speed Sensor - Subaru IMPREZA 2002 Service Manual

I
VEHICLE SPEED SENSOR
MANUAL TRANSMISSION
AND
DIFFERENTIAL
7. Vehicle Speed Sensor
A: REMOVAL
1 ) Disconnect the ground terminal from battery.
2) Lift-up the vehicle.
3) Remove the front and center exhaust pipes.
4) Disconnect the connector from vehicle speed
sensor.
5 ) Turn and remove the vehicle speed sensor.
-8: INSTALLATION
NOTE:
Discard the vehicle speed sensor and after re-
moval, replace with a new one.
Ensure the sensor mounting hole is clean and
free of foreign matter.
Align the tip end of key with key groove on the
end of speedometer shaft during installation.
1) Hand tighten the vehicle speed sensor.
2) Tighten the vehicle speed sensor using suitable
tool.
Tightening torque:
3) Connect the connector to vehicle speed sensor.
4) Install the front and center exhaust pipes.
5 ) Lower the vehicle.
6) Connect the battery ground terminal.
C: INSPECTION
Inspect the vehicle speed sensor.
Non-Turbo model
<Ref. to EN(S0HC)-238, DTC PO500 - VEHICLE
SPEED SENSOR MALFUNCTION -, Diagnostic
Procedure with Diagnostic Trouble Code (DTC).>
Turbo model
<Ref. to EN(D0HC TURBO)-246, DTC PO500 -
Diagnostic Procedure with Diagnostic Trouble
Code (DTC).>
5.9 N-m (0.6 kgf-m, 4.3 ff-lb)
VEHICLE SPEED SENSOR MALFUNCTION
-,
MT-39