Subaru IMPREZA 2002 Service Manual page 29

I
SELECT CABLE
I
CONTROL SYSTEMS
B: INSTALLATION
1) Install the select cable to plate assembly.
Tightening torque:
2) Install the select cable to range select lever.
3) Install the plate assembly to transmission.
Tightening torque:
32 N.m (3.3 kgf-m, 24 fi-lb)
T: 24.5 N-m (2.5 kgf-m, 18.1 ft-lb)
c .
(A) Select cable
(B) Plate ASSY
4) Install the snap pin to range select lever
(A) Range select lever
(B) Snap pin
(C) Select cable
(D) Clamp
5) Move the select lever to the "N" position, then ad-
just the select cable position. <Ref. to CS-27, AD-
JUSTMENT, Select Cable.>
6) Install the heat shield cover. (If equipped)
7) Install the front and center exhaust pipe. (Non-
turbo model) <Ref. to EX(S0HC)-6, INSTALLA-
TION, Front Exhaust Pipe.>
8) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(D0HC TURBO)-9, INSTALLATION,
Center Exhaust Pipe.>
C: INSPECTION
Check the removed cable and replace if damaged,
rusty, or malfunctioning.
1) Check for smooth operation of the cable.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends, and
cracks.
4) Check the boot for damage, cracks, and deterio-
ration.
5) Move the select lever from "P" position to "1" po-
sition. You should be able to feel the detentes in
each position. If the detentes cannot be felt or the
position pointer is improperly aligned, adjust the ca-
ble.
D: ADJUSTMENT
1) Set the vehicle on the lift.
2) Disconnect the ground terminal from battery.
3) Set the lever to "N" position.
4) Lift-up the vehicle.
5) Remove the rear exhaust pipe and muffler.
6) Remove the heat shield cover. (If equipped)
7) Loosen the adjusting nut on each side.
I /
03M1792A
(A) Adjusting nut A
(B) Adjusting nut B
CS-27