Subaru IMPREZA 2002 Service Manual page 275

REVERSE CHECK SLEEVE
I
MANUAL TRANSMISSION AND DIFFERENTIAL
C: DISASSEMBLY
1) Cover the reverse check sleeve with a rag, and
remove snap ring using a screwdriver.
NOTE:
Replace the snap ring with a new one if deformed
or weakened.
B3M1383C
(A) Snap ring
2) Remove the reverse check plate, reverse check
'spring, reverse check cam, return spring (5th-Rev),
reverse accent shaft, return spring cap and return
spring (1st-2nd).
I
1
I
B3M1384A
I
(A)
Reverse check plate
(8) Reverse check spring
(C)
Return spring (5th-Rev)
(D)
Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
3) Remove O-ring.
NOTE:
Reverse check sleeve assembly uses an O-ring
which should not be scratched.
Be careful not to break adjustment shim placed
between reverse check sleeve assembly and case.
D: ASSEMBLY
1) Install the return spring (lst-2nd), return spring
cap, reverse accent shaft, check cam, return spring
and check spring onto reverse check sleeve.
NOTE:
Be sure the bent section of reverse check spring is
positioned in the groove in check cam.
I
B3M 1384A
(A) Reverse check spring
(B) Reverse check cam
(C) Return spring (5th-Rev)
(D) Reverse accent shaft
(E) Return spring cap
(F) Return spring (1st-2nd)
(G) Reverse check sleeve
2) Hook the bent section of reverse check spring
over reverse check plate.
3) Rotate the cam so that the protrusion of reverse
check cam is at the opening in plate.
4) With cam held in that position, install plate onto
reverse check sleeve and hold with snap ring.
5) Position O-ring in groove in sleeve.
MT-51