Subaru IMPREZA 2002 Service Manual page 35

I
CONTROL SYSTEMS
MT GEAR SHIFT LEVER
B: INSTALLATION
1) Install the joint to the transmission and secure
with the straight pin.
2) Insert the gear shift lever from room side.
NOTE:
After inserting the rod and stay, temporarily put
them onto transmission mount.
3)
Lift-up the vehicle.
5) Insert the spring pin.
c .
4) Install the joint to shifter arm.
(A) Joint
(B) Spring pin
6) Mount the cushion rubber on the body.
Tightening torque:
18 N-m (1.8 kgf-m, 13.0 ff-lb)
7) Connect the rod to the joint.
Tightening torque:
18 N.m (1.8 kgf-m, 73.0 ff-lb)
(A) Stay
(B) Rod
8) Connect the stay to transmission bracket.
Tightening torque:
18 N-m (1.8 kgf-m, 13.0 ff-lb)
(A) Stay
(B) Transmission bracket
9) Install the heat shield cover. (If equipped)
IO) Install the rear exhaust pipe and muffler.
1 1 )
Lower the vehicle.
12) Install the boot plate to body.
Tightening torque:
7.5 N.m (0.76 kgf-m, 5.5 ff-lb)
13)
Install the consol box. <Ref. to El-41, INSTAL-
LATION, Console Box.>
(A) Stay
(B) Cushion rubber
cs-33