Speedometer Gear - Subaru IMPREZA 2002 Service Manual

SPEEDOMETER GEAR
I
MANUAL TRANSMISSION AND DIFFERENTIAL
18.Speedometer Gear
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to MT-27, REMOVAL, Manual
Transmission Assembly.>
2) Remove the back-up light switch and neutral po-
sition switch. <Ref. to MT-37, REMOVAL, Switches
and Harness.>
3) Remove the transfer case with extension case
assembly. <Ref. to MT-41, REMOVAL, Transfer
Case and Extension Case Assembly.>
4) Remove the transmission case. <Ref. to MT-54,
REMOVAL, Transmission Case.>
5) Remove the vehicle speed sensor. <Ref. to MT-
39, REMOVAL, Vehicle Speed Sensor.>
6) Remove the outer snap ring and pull out the
speedometer driven gear. Next, remove the oil
seal, speedometer shaft and washer.
r .
/
B3M0525C
(A) Outer snap ring
(B) Speedometer driven gear
B: INSTALLATION
1) Install the washer and speedometer shaft, and
press fit oil seal with ST.
CAUTION:
Use new oil seal, if it has been removed.
ST 8998241 00 or 499827000PRESS
2) Install the vehicle speed sensor. <Ref. to MT-39,
INSTALLATION, Vehicle Speed Sensor.>
3) Install the speedometer driven gear and snap
ring.
CAUTION:
Use new snap ring, if it has been removed.
(A) Outer snap ring
(B) Speedometer driven gear
4) Install the transmission case. <Ref. to MT-55, IN-
STALLATION, Transmission Case.>
5) Install the transfer case with extension case as-
sembly. <Ref. to MT-41, INSTALLATION, Transfer
Case and Extension Case Assembly.>
6) Install the back-up light switch and neutral posi-
tion switch. <Ref. to MT-38, INSTALLATION,
Switches and Harness.>
7) Install the manual transmission assembly to ve-
hicle.<Ref. to MT-30, INSTALLATION, Manual
Transmission Assembly.>
C: INSPECTION
Check the speedometer gear, oil seal and speed-
ometer shaft for damage. Replace if damaged.
MT-77