Select Lever - Subaru IMPREZA 2002 Service Manual

I
SELECT LEVER
CONTROL SYSTEMS
4.
Select Lever
A: REMOVAL
1) Set the vehicle on the lift.
2) Disconnect the ground terminal from battery.
3) Move the select lever to the "N" position.
4) Lift-up the vehicle.
5) Remove the rear exhaust pipe and muffler.
6) Remove the heat shield cover. (If equipped)
7) Disconnect the cable from select lever and then
remove the cable bracket.
(A) Adjusting nuts
(B) Cable bracket
8) Lower the vehicle.
9) Remove the console box. <Ref. to El-41, RE-
MOVAL, Console Box.>
10) Disconnect the connectors, then remove the
four bolts to take out the select lever assembly from
the body.
I1510
B: INSTALLATION
1) Mount the select lever onto the vehicle body.
2) Tighten the four bolts to install the select lever to
the vehicle body, then connect the connector.
Tightening torque:
13 N.m (1.3 kgf-m, 9.4 ft-lb)
3) Install the console box. <Ref. to El-39, INSTAL-
LATION, Glove Box.>
4) Set the location of select lever at 'IN" position.
5) Lift-up the vehicle.
6) Set the location of range select lever to "N" posi-
tion.
7) Insert the thread portion of the other inner cable
and into the connector hole of the select lever, and
fix the other outer cable end to the bracket.
8) Adjust the select cable position. <Ref. to CS-27,
ADJUSTMENT, Select Cable.>
9) After completion of fitting, make sure that the se-
lect lever operates smoothly all across the operat-
ing range.
10) Inspect the following items. If the following in-
spection reveals problems, adjust the select cable
and inhibitor switch. <Ref. to CS-27, ADJUST-
MENT, Select Cable.> and <Ref. to AT-28, AD-
JUSTMENT, Inhibitor Switch.>
(1) The engine starts operating when select le-
ver is in position "P", but not in other positions.
(2) The back-up light is lit when the select lever
is in position 'W, but not in other positions.
(3) Select lever and indicator positions are
matched.
(1) Ensure the ignition switch rotates from
"ACC" to "LOCK when the select lever is set at
"P". Also check that ignition key can be removed
only from the "LOCK position.
(2) Ensure the select lever moves from "P" to
any other position when the brake pedal is de-
pressed with ignition key set at "ON" or
"START.
11) Check the shift-lock system.
12) Install heat shield cover. (If equipped)
13) Install rear exhaust pipe and muffler.
CS-23