Subaru IMPREZA 2002 Service Manual page 291

il
DRIVE PINION SHAFT ASSEMBLY
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Install a set of roller bearings onto the driven
shaft using ST and press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1 .O Imp ton).
ST 499277200 INSTALLER
I I
G3M061 6
8) Position the woodruff key in groove on the rear of
driven shaft. Install 5th driven gear onto drive shaft
using ST and press.
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1 .O Imp ton).
ST 499277200 INSTALLER
r .
G3M0617
9) Install the lock washer. Install lock nut and tight-
en to the specified torque using ST.
ST 499987300 SOCKET WRENCH (50)
Tightening torque:
265 N.m (27 kgf-m, 195 ff-lb)
I
.
NOTE:
Stake the lock nut at two points.
Using spring balancer, check that starting torque
of roller bearing is 0.1 to 1.5 N (0.01 to 0.15 kgf,
0.02 to 0.33ft).
10) Install the roller bearing onto drive pinion.
NOTE:
When installing roller bearing, note its directions
(front and rear) because the knock pin hole in outer
race is offset.
( B ) B3M1661 A
' \
(A) Roller bearing
(B) Knock pin hole
11) Install the washer using STI, ST2 and press.
CAUTION:
Discard old lock nuts, replace with new ones.
Secure lock nut in four places.
ST2 499277200 INSTALLER
STI
4992771 00 BUSH 1-2 INSTALLER
(A) Washer
MT-67