Subaru IMPREZA 2002 Service Manual page 74

Hide thumbs Also See for IMPREZA 2002:
Table of Contents

Advertisement

FRONT VEHICLE SPEED SENSOR
AUTOMATIC TRANSMISSION
I
2) Connect the harness connectors.
Connect the connectors of same color, and secure
the connectors to valve body sing clips.
Tightening torque (Transmission ground termi-
nal):
8 N-m (0.8 kgf-m, 5.8 ft-lb)
B2M22631
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
Line pressure duty solenoid (Red)
Shift solenoid 2 (Yellow)
Shift solenoid 1 (Green)
2-4 brake timing solenoid (Black)
2-4 brake duty solenoid (Red)
ATF temperature sensor
Transfer duty solenoid (Brown)
Transmission ground
3) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
Fluid packing:
Three Bond 12176
I
B3M1040
4) Install the oil pan.
Tightening torque:
5) Install the front and rear vehicle speed sensor,
and also the torque converter turbine speed sen-
sor, and then fasten the harness.
Tightening torque:
7 N-m (0.7 kgf-m, 5. 1 ft-lb)
25 N-m (2.5 kgf-m, 18.1 ff-lb)
6) Install the oil cooler outlet pipe.
CAUTION:
Be sure to use a new aluminum washer.
Tightening torque:
7) Install the transmission rear crossmember bolts.
Tightening torque:
75 Nom (7.6 kgf-m, 55 ft-lb)
8 ) Install the propeller shaft. <Ref. to DS-15, IN-
STALLATI ON, P rope I le r Shaft. >
9) Install the shield cover. (If equipped)
10) Install the front, center, rear exhaust pipes and
muffler. (Non-turbo model)
<Ref. to EX(S0HC)-6, INSTALLATION, Front Ex-
haust Pipe.> and <Ref. to EX(S0HC)-9, INSTAL-
LATION, Rear Exhaust Pipe.> and <Ref. to
EX(S0HC)-1 1, INSTALLATION, Muffler.>
11) Install the center, rear exhaust pipes and muf-
fler. (Turbo model) <Ref. to EX(D0HC TURBO)-
14, INSTALLATION, Muffler.>, <Ref. to EX(D0HC
TURBO)-1 3,
INSTALLATION, Rear
Exhaust
Pipe.>, <Ref. to EX(D0HC TURBO)-9, INSTALLA-
TION, Center Exhaust Pipe.>
12) Lower the vehicle.
13) Install the transmission connector to the stay.
14) Install the air cleaner case. (Non-turbo model)
<Ref. to IN(S0HC)-6, INSTALLATION, Air Cleaner
Case.>
15) Install the intercooler. (Turbo model). <Ref. to
IN(D0HC TURBO)-1 1, INSTALLATION, Intercool-
er.>
25 N-m (2.5 kgf-m, 18.1 ft-lb)
AT-34

Advertisement

Table of Contents
loading

Table of Contents