Mounting; Mounting The Drive; Mounting Orientation And Clearance - Siemens SINAMICS V90 Operating Instructions Manual

Mounting

3.1

Mounting the drive

For mounting conditions, see Technical data - servo drives (Page 43).
3.1.1

Mounting orientation and clearance

Mount the drive vertically in a shielded cabinet and observe the mounting clearances
specified in the illustration below:
Note
The drive must be derated to 80% when the following conditions are satisfied:
• The surrounding temperature is 0 °C to 45 °C, and the mounting clearance is less than
10 mm. In this case, the minimum mounting clearance should not be less than 5 mm.
• The surrounding temperature is 45 °C to 55 °C. In this case, the minimum mounting
clearance should not be less than 20 mm.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 07/2015, 6SL3298-0AV60-0BP0
3
53