Siemens SINAMICS V90 Operating Instructions Manual page 23

Note
Voltage requirement
Before switching the power on, make sure that the drive system has been reliably installed
and connected, and the line supply voltage is within the allowable range.
Note
Drive functioning interfered by use of radio devices
Some environmental factors may result in power derating, e.g. altitude and surrounding
temperature. In this case, the drive cannot work normally.
Environmental factors must be taken into account during commissioning or operation.
Troubleshooting
Drive remaining charged
The drive may remain charged in a short period after it is powered off.
Touching terminals or disassembling cables may cause minor injury due to electrical shock.
Do not touch terminals or disassemble cables until the drive system has been disconnected
for at least five minutes.
Personal injury due to unexpected restart
The machine might unexpectedly restart after the power supply that was suddenly switched
off is switched on again. Touching the machine at this time may cause personal injury.
Do not approach the machine after the power supply is switched on again.
Disposal
Note
Equipment disposal
Disposal of the equipment must be made in accordance with the regulations of the
competent environmental protection administration on the disposal of electronic wastes.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 07/2015, 6SL3298-0AV60-0BP0
WARNING
WARNING
Safety instructions
1.2 Additional safety instructions
23