Appendix
A.3 Assembly of cable terminals on the drive side
A.3
Assembly of cable terminals on the drive side
Power terminal assembly
Drive type
Procedure
FSA/FSAA
Terminal assembly procedure:
1. Remove the outer sheath of the cable.
2. Remove the insulation from the wire.
3. Insert the stripped end into the cable end
sleeve.
4. Crimp the cable end sleeve using a crimp
tool for end sleeves.
FSB/FSC
Terminal assembly procedure:
1. Remove the outer sheath of the cable.
2. Remove the insulation from the wire.
3. Insert the stripped end into the spade termi-
nal.
4. Crimp the spade terminal using a crimp tool
for cable lugs. (Note: Coat any exposed wires
with tin.)
318
Illustration
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 07/2015, 6SL3298-0AV60-0BP0