Residual Risks During The Operation Of Electric Motors - Siemens SINAMICS V90 Operating Instructions Manual

Information regarding non-Siemens products
Note
Non-Siemens products
This document contains recommendations relating to non-Siemens products. Non-Siemens
products whose fundamental suitability is familiar to us. It goes without saying that equivalent
products from other manufacturers may be used. Our recommendations are to be seen as
helpful information, not as requirements or dictates. We cannot accept any liability for the
quality and properties/features of non-Siemens products.
Warning labels
Warning labels attached to the motor or drive have the following meanings:
Symbol
1.2.1

Residual risks during the operation of electric motors

The motors may be operated only when all protective equipment is used.
Motors may be handled only by qualified and instructed qualified personnel that knows and
observes all safety instructions for the motors that are explained in the associated technical
user documentation.
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 07/2015, 6SL3298-0AV60-0BP0
Description
Risk of electric shock
Do not touch any terminals or disassemble cables until the drive has been
disconnected from power for at least five minutes.
Caution
Pay attention to the information given on the rating plate and operating
instructions.
For more information, refer to this manual.
Hot surface
Do not touch the heatsink of the drive during operation or within a certain
period since power disconnection because its surface temperature may
reach up to 65 °C.
No knocking at the shaft
Do not exert any shock at the shaft end; otherwise, the encoder may be
damaged.
Protective conductor terminal
Safety instructions
1.2 Additional safety instructions
25