Transferring Data (Drive To Sd) - Siemens SINAMICS V90 Operating Instructions Manual

Basic operator panel (BOP)
6.5 Auxiliary functions
Note
You must save the parameter set after setting the parameter set to the default values;
otherwise, the default values will not be activated.
Reference
Saving parameters (RAM to ROM) (Page 129)
6.5.4

Transferring data (drive to SD)

You can save the parameter set from the drive ROM to an SD card with the BOP. To do this,
proceed as follows:
NOTICE
It is forbidden to use this function when the servo is ON.
Use this function when the servo is OFF.
NOTICE
Plugging or unplugging the SD card will cause copying failure.
Do not plug or unplug the SD card during copying; otherwise, the copying operation will fail.
Note
Write protection function is not supported by SINAMICS V90. Data in the SD card will be
overwritten even if the write protection function of the SD card is enabled.
130
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 07/2015, 6SL3298-0AV60-0BP0