Tektronix MSO2024B Programmer's Manual page 98

Commands Listed in Alphabetical Order
Syntax
Arguments
BUS:B<x>:POSition
Conditions
Group
Syntax
Arguments
BUS:B<x>:RS232C:BITRate
Conditions
Group
Syntax
Arguments
2-82 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual
BUS:B<x>:PARallel:WIDth <NR1>
BUS:B<x>:PARallel:WIDth?
is the number of bits.
<NR1>
Sets or returns the position of the bus <x> waveform on the display, where x is
the bus number 1 through 4.
This command requires a DPO2AUTO, DPO2EMBD, or DPO2COMP application
module.
Bus
BUS:B<x>:POSition <NR3>
BUS:B<x>:POSition?
specifies the position.
<NR3>
Sets or returns the RS232 bit rate for bus <x>, where x is the bus number.
This command requires a DPO2COMP application module.
Bus
BUS:B<x>:RS232C:BITRate <NR1>
BUS:B<x>:RS232C:BITRate?
is the bit rate in bits-per-second: 50 to 10000000. You can enter any
<NR1>
positive integer, and the instrument will coerce the value to the closest supported
bit rate.