Tektronix MSO2024B Programmer's Manual page 77

Group
Syntax
Related Commands
Returns
ACQuire:NUMAVg
Group
Syntax
Related Commands
Arguments
Examples
ACQuire:STATE
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual
start acquisitions again, it will continue from 5000. The number will reset to 0
only if you change the horizontal scale while acquisitions are running.
Acquisition
ACQuire:NUMACq?
ACQuire:STATE
might return
ACQuire:NUMACq?
acquisitions have occurred.
Sets or returns the number of waveform acquisitions that make up an averaged
waveform. Use the ACQuire:MODe
Sending this command is equivalent to turning a multipurpose knob to enter the
number of waveform acquisitions to average.
Acquisition
ACQuire:NUMAVg <NR1>
ACQuire:NUMAVg?
ACQuire:MODe
is the number of waveform acquisitions to average. The range of values is
<NR1>
from 2 to 512 in powers of two.
specifies that 16 waveform averages will be performed
ACQUIRE:NUMAVG 16
before exponential averaging starts.
might return
ACQUIRE:NUMAVG?
are 64 acquisitions specified for averaging.
Starts or stops acquisitions. When state is set to ON or RUN, a new acquisition
will be started. If the last acquisition was a single acquisition sequence, a new
Commands Listed in Alphabetical Order
:ACQUIRE:NUMACQ 350
command to enable the Average mode.
:ACQUIRE:NUMAVG 64
indicating that 350
indicating that there
2-61