Tektronix MSO2024B Programmer's Manual page 222

Commands Listed in Alphabetical Order
MEASUrement:MEAS<x>:UNIts? (Query Only)
Group
Syntax
Related Commands
Examples
MEASUrement:MEAS<x>:VALue? (Query Only)
Group
Syntax
Related Commands
Examples
2-206 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual
MEASUREMENT:MEAS1:TYPE?
indicating that measurement 1 is defined to measure the RMS value of a waveform.
Returns the units associated with the specified measurement. The measurement
slots are specified by <x>, which ranges from 1 through 4.
Measurement
MEASUrement:MEAS<x>:UNIts?
MEASUrement:MEAS<x>:TYPe
MEASUREMENT:MEAS1:UNITS?
indicating units for measurement 1 are set to percent.
Returns a calculate value for the measurement specified by <x>, which ranges
from 1 through 4.
NOTE.
This is the same value as displayed on-screen. If measurement statistics
are enabled, a new value is calculated with every waveform. In addition, this
value is updated approximately every 1/3 second. If you are acquiring a long
acquisition record, the oscilloscope may take longer to update.
Measurement
MEASUrement:MEAS<x>:VALue?
MEASUrement:MEAS<x>:UNIts?, *ESR?,
MEASUREMENT:MEAS1:VALUE?
. If the measurement has an error or warning associated with it,
2.8740E-06
then an item is added to the error queue. The error can be checked for with the
*ESR? and ALLEv? commands.
might return
:MEASUREMENT:MEAS1:TYPE RMS
might return
:MEASUREMENT:MEAS1:UNIts %
ALLEv?
might return
:MEASUREMENT:MEAS1:VALue