Tektronix MSO2024B Programmer's Manual page 166

Commands Listed in Alphabetical Order
Syntax
Arguments
Examples
ETHERnet:IPADDress
Group
Syntax
Arguments
Examples
ETHERnet:NAME
Group
Syntax
Arguments
2-150 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual
ETHERnet:HTTPPort <QString>
ETHERnet:HTTPPort?
is an integer port number, enclosed in quotes.
<QString>
NOTE.
Consider the following if you are using the e*Scope™ control software. If
you don't enter a port address in the URL, then the
must be set to "80", which is the default port for HTTP protocol. If you use a
URL with a port address (for example: http://DPO2004-04WKL4:1234), the port
number is specified by the number after the colon. Set the
value to this same number.
ETHERNET:HTTPPORT "80"
Sets or returns the IP address assigned to the oscilloscope.
Ethernet
ETHERnet:IPADDress <QString>
ETHERnet:IPADDress?
<QString> is a standard IP address value, enclosed in quotes.
ETHERNET:IPADDRESS
Sets or returns the network name assigned to the oscilloscope.
Ethernet
ETHERnet:NAME <QString>
ETHERnet:NAME?
is the network name assigned to the oscilloscope, enclosed in quotes.
<QString>
sets the HTTP port value to 80.
"123.121.13.214" sets the oscilloscope's IP address.
value
ETHERnet:HTTPPort
ETHERnet:HTTPPort