Tektronix MSO2024B Programmer's Manual page 152

Commands Listed in Alphabetical Order
Arguments
Examples
DIAg:LOOP:OPTion:NTIMes
Group
Syntax
Arguments
Examples
DIAg:LOOP:STOP (No Query Form)
Group
Syntax
Examples
2-136 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual
continues looping until the self tests (diagnostics) are stopped via the
ALWAYS
front panel or by an oscilloscope command.
causes looping until the first self test (diagnostic) failure or until self tests
FAIL
(diagnostics) are stopped.
causes looping on a specific test group as long as a FAIL status is
ONFAIL
returned from the test.
executes self test (diagnostics test) sequence once.
ONCE
runs "n" number of loops.
NTIMES
DIAG:LOOP:OPTION ONCE
Sets the self-test loop option to run N times.
Calibration and Diagnostic
DIAg:LOOP:OPTion:NTIMes <NR1>
DIAg:LOOP:OPTion:NTIMes?
is the number of self-test loops.
<NR1>
DIAG:LOOP:OPTION:NTIMES 3
DIAG:LOOP:OPTION:NTIMES?
indicating that the self-test loop is set to run five times.
Stops the self-test at the end of the current loop.
Calibration and Diagnostic
DIAg:LOOP:STOP
stops the self test at the end of the current loop.
DIAG:LOOP:STOP
runs one loop of self tests.
sets the self-test loop to run three times.
might return
:DIAG:LOOP:OPTION:NTIMES 5
,