Tektronix MSO2024B Programmer's Manual page 356

Commands Listed in Alphabetical Order
Arguments
Examples
TRIGger:A{:TRANsition|:RISEFall}:SOUrce
Group
Syntax
Arguments
Examples
TRIGger:A{:TRANsition|:RISEFall}:WHEn
Group
2-340 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual
indicates that a pulse edge must traverse from the lower (most
POSitive
negative) to higher (most positive) level for transition triggering to occur.
indicates that a pulse edge must traverse from the upper (most positive)
NEGative
to lower (most negative) level for transition triggering to occur.
indicates either positive or negative polarity.
EITher
TRIGGER:A:TRAnsITION:POLARITY NEGATIVE
negative.
TRIGGER:A:TRAnsITION:POLARITY?
TRANSITION:POLARITY EITHER
positive or negative.
Sets or returns the source for transition trigger.
Trigger
TRIGger:A{:TRANsition|:RISEFall}:SOUrce {CH1|CH2|CH3|CH4|
D0|D1|D2|D3|D4|D5|D6|D7|D8|D9|D10|D11|D12|D13|D14|D15}
TRIGger:A{:TRANsition|:RISEFall}:SOUrce?
specifies one of the input channels.
CH1–CH4
specifies one of the input digital channels.
D0–D15
TRIGGER:A:TRAnsITION:SOURCE CH4
transition trigger.
TRIGGER:A:TRAnsITION:SOURCE?
indicating that channel 2 is the source for the A transition trigger.
SOURCE CH2
Sets or returns whether to check for a transitioning signal that is faster or slower
than the specified delta time.
Trigger
sets the transition polarity to
might return
:TRIGGER:A:
indicating that the polarity can be either
sets channel 4 as the source for the
might return
:TRIGGER:A:TRANSITION: