General Settings - TRENDnet TI-PG1284i User Manual

TRENDnet User's Guide
duplex mode to send a "collision" signal to the sending port (mimicking a state of packet
collision) causing the sending port to temporarily stop sending signals and resend later.
Note: 1000 Base-T doesn't support force mode.

Cable Test.
This feature determines the quality of the cables, shorts, and cable impedance mismatch,
bad connectors, termination mismatch, and bad magnetics. The feature can work on the
copper Ethernet cable only.
Default Settings
The default port Speed & Duplex is auto for all ports.
The default port Flow Control is Off for all ports.
© Copyright 2016 TRENDnet. All Rights Reserved.

General Settings

CLI Configuration
Node Command
enable show interface IFNAME
configure interface IFNAME
interface show
interface loopback (none | mac)
interface flowcontrol (off | on)
interface speed (auto|10-full||10-half|
100-full|100-half|1000-full)
interface shutdown
interface no shutdown
interface description STRINGs
interface no description
interface cable test
interface clean cable-test result
interface show cable-test result
TI-PG1284i
Description
This command displays the current
port configurations.
This command enters the interface
configure node.
This command displays the current
port configurations.
This command tests the loopback
mode of operation for the specific
port.
This command disables / enables
the flow control for the port.
This command configures the
speed and duplex for the port.
This command disables the specific
port.
This command enables the specific
port.
This command configures a
description for the specific port.
This command configures the
default port description.
This command diagnostics the
Ethernet cable and shows the
broken distance.
This command cleans the test
result of the Ethernet cable test.
This command displays the test
result of the Ethernet cable test.
29