Table of Contents
Advertisement
TRENDnet User's Guide
if-range
spanning-tree
rootguard
(disable|enable)
if-range
spanning-tree edge-
port (disable|enable)
if-range
spanning-tree cost
VALUE
if-range
no spanning-tree cost
if-range
spanning-tree port-
priority <0-240>
if-range
no spanning-tree port-
priority
© Copyright 2016 TRENDnet. All Rights Reserved.
This command enables/disables the BPDU
Root guard port setting for the specific port.
This command enables/disables the edge
port setting for the specific port.
This command configures the cost for the
specific port.
Cost range:
16-bit based value range 1-65535,
32-bit based value range 1-200000000.
This command configures the path cost to
default for the specific port.
This command configures the port priority for
the specific port.
Default: 128.
This command configures the port priority to
default for the specific port.
Web Configuration
General Settings
Advanced Settings > STP > General Settings
Parameter
Description
Select Enabled to use Spanning Tree Protocol (STP) or Rapid Spanning
State
Tree Protocol (RSTP).
Select to use either Spanning Tree Protocol (STP) or Rapid Spanning Tree
Mode
Protocol (RSTP).
This is the maximum time (in seconds) the Switch will wait before
changing states. This delay is required because every switch must receive
Forward
information about topology changes before it starts to forward frames.
Time
In addition, each port needs time to listen for conflicting information that
would make it return to a blocking state; otherwise, temporary data
loops might result. The allowed range is 4 to 30 seconds.
This is the maximum time (in seconds) the Switch can wait without
Max Age
receiving a BPDU before attempting to reconfigure. All Switch ports
(except for designated ports) should receive BPDUs at regular intervals.
TI-PG1284i
123
Hide quick links:
Advertisement
Table of Contents
