Jumbo Frame - TRENDnet TI-PG1284i User Manual

TRENDnet User's Guide
Web Configuration
Basic Settings > General Settings > System
Configures a IPv4 address for your Switch in dotted decimal
IP Address
notation. For example, 192.168.10.200.
Enter the IP subnet mask of your Switch in dotted decimal
Subnet Mask
notation for example 255.255.255.0.
Enter the IP address of the default outgoing gateway in dotted
Default Gateway
decimal notation, for example 192.168.10.1.
IPv6 Settings
Select Enable to allow the Switch to automatically get an IP
DHCPv6 Client
address from a DHCPv6 server. Click Renew to have the Switch
re-get an IP address from the DHCP server.
© Copyright 2016 TRENDnet. All Rights Reserved.
Select Disable if you want to configure the Switch's IP address
manually.
Global Address Configure a global IPv6 address for the Switch.
Set – Set an IPv6 default gateway for the Switch.
Default Gateway
Unset – Unset the IPv6 default gateway for the Switch.
Apply
Click this button to take effect the settings.
Refresh
Click this button to reset the fields to the last setting.

Jumbo Frame

Jumbo frames are Ethernet frames with a payload greater than 1500 bytes. Jumbo frames
can enhance data transmission efficiency in a network. The bigger the frame size, the
better the performance.
Notice:
The jumbo frame settings will apply to all ports.
If the size of a packet exceeds the jumbo frame size, the packet will be dropped.
The available values are 1522, 1536, 1552, 9010, 9216, 10240.
Default Settings
The default jumbo frame is 10240 bytes.
CLI Configuration
Node Command
enable show jumboframe
TI-PG1284i
Description
This command displays the
current jumbo frame settings.
17