TRENDnet TI-PG1284i User Manual page 19

TRENDnet User's Guide
eth0 management vlan VLANID
eth0 ip ipv6-address
AAAA:BBBB:CCCC:DDDD:EEEE:FFFF:GGGG:HHHH/M
eth0 ip ipv6-address default-gateway
AAAA:BBBB:CCCC:DDDD:EEEE:FFFF:GGGG:HHHH
eth0 ip ipv6-dhcp client (disable|enable|renew)
© Copyright 2016 TRENDnet. All Rights Reserved.
Example: The procedures to configure an IP address for the Switch.
client function for
the system.

To enter the configure node.
Disable: Use a
TI-PG1284I#configure terminal
static IP address
TI-PG1284I(config)#
on the switch.
Enable & Renew:

To enter the ETH0 interface node.
Use DHCP client to
TI-PG1284I(config)#interface eth0
get an IP address
from DHCP server.
TI-PG1284I(config-if)#
This command
configures the 
To get an IP address from a DHCP server.
management vlan.
TI-PG1284I(config-if)#ip dhcp client enable
This command
configures a global

To configure a static IP address and a gateway for the Switch.
scope of IPv6
TI-PG1284I(config-if)#ip address 192.168.202.111/24
address and
TI-PG1284I(config-if)#ip address default-gateway 192.168.202.1
subnet mask for
the system.

To configure a static global IPv6 address and a gateway for the Switch.
This command

configures a
default gateway
TI-PG1284I(config-if)#ip ipv6-address 3ffe::1235/64
for the system.

This command
configures a
TI-PG1284I(config-if)#ip ipv6-address default-gateway 3ffe::1234
DHCPv6 client
function for the
system.
Disable: Use a
static IP address
on the switch.
Enable & Renew:
Use DHCPv6 client
to get an IP
address from
DHCPv6 server.
Please set the static global IPv6 address first.
And the set the IPv6 default gateway address.
TI-PG1284i
16