TRENDnet TI-PG1284i User Manual page 125

TRENDnet User's Guide
max-age TIME hello-
time TIME
configure no spanning-tree
algorithm-timer
configure spanning-tree forward-
time <4-30>
configure no spanning-tree
forward-time
configure spanning-tree hello-
time <1-10>
configure no spanning-tree hello-
time
configure spanning-tree max-age
<6-40>
configure no spanning-tree max-
age
configure spanning-tree mode
(rstp|stp)
configure spanning-tree pathcost
method (short|long)
configure spanning-tree priority
<0-61440>
configure no spanning-tree
priority
interface spanning-tree
(disable|enable)
interface spanning-tree
bpdufilter
(disable|enable)
© Copyright 2016 TRENDnet. All Rights Reserved.
This command configures the default values
for forward-time & max-age & hello-time.
This command configures the bridge forward
delay time (sec).
This command configures the default values
for forward-time.
This command configures the bridge hello
time(sec).
This command configures the default values
for hello-time.
This command configures the bridge message
max-age time(sec).
This command configures the default values
for max-age time.
This command configures the spanning
mode.
This command configures the pathcost
method.
This command configures the priority for the
system.
This command configures the default values
for the system priority.
This command configures enables/disables
the STP function for the specific port.
This command configures enables/disables
the bpdufilter function for the specific port.
interface spanning-tree
bpduguard
(disable|enable)
interface spanning-tree
rootguard
(disable|enable)
interface spanning-tree edge-
port (disable|enable)
interface spanning-tree cost
VALUE
interface no spanning-tree cost
interface spanning-tree port-
priority <0-240>
interface no spanning-tree port-
priority
configure interface range
gigabitethernet1/0/
PORTLISTS
if-range spanning-tree
(disable|enable)
if-range spanning-tree
bpdufilter
(disable|enable)
if-range spanning-tree
bpduguard
(disable|enable)
TI-PG1284i
This command configures enables/disables
the bpduguard function for the specific port.
This command enables/disables the BPDU
Root guard port setting for the specific port.
This command enables/disables the edge
port setting for the specific port.
This command configures the cost for the
specific port.
Cost range:
16-bit based value range 1-65535,
32-bit based value range 1-200000000.
This command configures the path cost to
default for the specific port.
This command configures the port priority for
the specific port.
Default: 128.
This command configures the port priority to
default for the specific port.
This command enters the interface configure
node.
This command configures enables/disables
the STP function for the specific port.
This command configures enables/disables
the bpdufilter function for the specific port.
This command configures enables/disables
the bpduguard function for the specific port.
122